Skip to content
Tomorrow'sTek
Maintenance

Porsche Macan Oil Change: Full DIY Oil and Filter Service

A complete oil and filter change on a 2017 Porsche Macan Turbo with no lift: off-road mode for clearance, the MAHLE filter swap, refill, an electronic level check, and a V6 oil leak worth looking for while you are under there.

Porsche Macan Oil Change DIY | Full Oil & Filter Service (2017 Macan Turbo)Watch on YouTube ↗
In this article
  1. What you need
  2. Step by step
  3. While you're under there: the V6 front plate leak
  4. How often
  5. Keep track of it

Our 2017 Macan Turbo was 544 miles past due for its oil service, so we did the whole job in the garage: drain, new MAHLE filter, new drain plug, fresh oil and a level check. You don't need a lift. On a Macan with air suspension, off-road mode raises the car enough to work underneath. The video above walks through the full service.[1]

What you need

Parts

  • Engine oil. The recommended grade is 0W-40. We used Liqui Moly 5W-40 full synthetic instead, because central Texas summers regularly pass 100°F. Whatever you buy, check that the bottle lists Porsche approval for your engine.
  • A MAHLE OX 254D4 oil filter kit, which includes a new O-ring. This is what fit our 2017 Macan Turbo; confirm the fit for your engine.
  • A new drain plug.
  • Optional: Liqui Moly Cera Tec, 300 mL. We add it at every oil change.
  • Enough oil for your engine's capacity. We used all of one 5-liter jug and part of a second.

Tools

  • 8 mm hex (Allen) socket for the drain plug
  • An adjustable wrench for the oil filter housing
  • An oil drain pan
  • A small hook tool to lift the old filter out (optional, but it helps)
  • A Porsche-capable scan tool or PIWIS to check the oil level and reset the service reminder

Step by step

  1. Warm the engine up so the oil drains freely, then shut it off.
  2. Open the hood and take off the oil filler cap so the oil drains faster.
  3. If your Macan has air suspension, raise it with off-road mode to get room underneath. Otherwise use ramps or proper jack stands. Never work under a car held up only by a jack.
  4. Set the drain pan in place and remove the drain plug with the 8 mm hex.
  5. While it drains, loosen the oil filter housing with the wrench. You don't need to be under the car for this part. Let it drip for a minute, then lift the old filter out.
  6. Swap the O-ring on the housing for the new one from the filter kit, and wipe a little fresh oil on it.
  7. Fit the new filter, thread the housing back in by hand until it seats, then tighten it to the torque printed on the housing.
  8. Once the oil has slowed to a drip, install the new drain plug and wipe everything clean.
  9. Refill through the filler neck. Pour in most of the oil, add the Cera Tec if you use it, then top up in small amounts.
  10. Check the level. The Macan has no dipstick, so read it electronically. Our PIWIS showed "oil level correct."
  11. Reset the service reminder and put a fresh service sticker on.

While you're under there: the V6 front plate leak

On the V6 turbo engines, oil on the front engine plate is a common find. On our car it traced back to two bolts on that plate that we believe were over-tightened at the factory, and a replacement bolt kit fixes it. That repair gets its own video. If you see fresh oil on the front of the engine while the car is up, check there first.

How often

Our old filter had about 10,000 miles on it. Follow the oil service interval for your car, and shorten it if you drive hard or in serious heat.

Keep track of it

We logged this service in TekGarage, which also shows the parts, the additives and what's coming due next. Questions about your Macan? Ask in the Macan forum or the Porsche Technical Support group on Facebook. For other common Macan problems, see the Macan owner's guide.

Sources

  1. Porsche Macan Oil Change DIY | Full Oil & Filter Service (2017 Macan Turbo)Tomorrow’sTek on YouTube · July 24, 2026 · accessed November 12, 2026Primary

Topicsporsche macan · oil change · macan turbo · liqui moly · mahle filter · diy maintenance

Filed underMaintenance

Published by

The Tomorrow’sTek Editorial Team

About Tomorrow’sTek →